Skip to content
EN

CNC cutting service

Composite cutting

Your drawing is CNC-cut from 3D woven carbon plate and shipped.

  • Instant dimensions and layout from a DXF drawing
  • 6.5 mm 3D woven structural carbon plate
  • Cuttable area 490 × 240 mm
Upload your drawing

Part quote

The DXF drawing is measured in your browser: the cut length (the total contour length the end mill follows), the hole count, the outer dimensions and the layout on the plate are shown. The part price is quoted after the drawing has been checked. DWG, STEP and PDF drawings are sent from the same area with a quote request.

To lay out several different parts on a plate yourself, use One Way Cutter. It is free and runs in your browser; cut files (DXF, SVG) download without an account.

File confidentiality

The file is not sent to a server for measurement and layout. It is transferred only with a quote request and used only for that job. A non-disclosure agreement (NDA) is signed on request.

Frequently asked questions

Does the calculator show a price?
No. When a DXF drawing is uploaded, the dimensions and the plate layout are shown; no price is calculated on the page. The drawing is sent with the quote request, checked before production, and the part price is sent to your email address.

Which file format is accepted for cutting?
For instant dimensions and plate layout, upload a 2D DXF file of up to 5 MB. The outline must be a closed polyline and the part must fit within 490 × 240 mm; units are read from the file and millimetres are assumed when none are set. DWG, STEP, STP and PDF drawings of up to 10 MB are uploaded in the same area. All drawings are priced by quote, and the part price is sent by email.

What is the strong direction?
It is the direction in which the plate shows its highest strength, running along its 490 mm edge. The load-bearing axis of the part is aligned with this direction; the required direction is stated in the quote request.

How is the cutting price determined?
The part price is determined by quotation, taking into account the number of plates the order uses, the contour cutting length, the number of holes and countersinks, setup and the required lead time. The calculator shows how many plates the order uses. There is no minimum order value. Plate offcuts left from cutting are shipped with the order unless otherwise specified.

All questions