Skip to content
EN

Company

About Us

Since 2011, 3D weaving machine design and composite production in Türkiye.

R&D started
2011
First machine produced
2013
First serial-production line
2016
Made in
Türkiye

Our Mission

3D woven preforms and composite parts are produced for applications where 2D laminates fall short on geometry, delamination resistance or production scale. The aim is to make complex geometries lightweight and mass-producible.

Loom design, preform engineering and vacuum-assisted resin transfer moulding (VARTM) sit with a single supplier; the transition from prototype to series production is seamless. Weave pattern, fiber and resin system are set to the part's design.

Our Mission — 3Dwovens
Warp creel of the 3D weaving loom

Our Story

Our team began prototype work on a 3D weaving machine in 2011, built the first machine in 2013, and installed the first serial-production line in 2016.

Ongoing R&D has extended our activity abroad; production today serves companies in Türkiye and overseas alike. We serve the defense, aerospace, space and automotive industries.

Our Capabilities

3D Weaving Machine Design & Manufacturing

The 3D weaving loom is a production line made up of warp preparation and bobbin transfer units and control cabinets. The entire line is developed in-house and used only in our own production.

The two software layers that drive the loom are also our own engineering: an automation layer controlling motors, sensors and motion axes in real time, and a pattern layer that translates the target 3D geometry into the fibre-and-bobbin matrix. The loom, the software and the whole production process are domestic engineering.

3D Woven Preform & Composite Production

Preform production takes as much experience as machine production. Every product gets its own engineering, setup and machine-to-product adaptation, in-house.

Pattern software, preform production and VARTM mould design are treated as a single whole. VARTM moulds are designed in-house to suit the preform and the resin system; preforms are converted into composite parts on our own VARTM line.

Our Team — 3Dwovens

Our Team

The team consists of mechanical, textile, materials and electronics engineers and experienced technicians. Every stage of loom, preform and VARTM production is carried out by the same team.